Menu navigation and adjustment values
Selection operation modes:
▪ Heating OFF
The heating system is switched off
▪ Heating time mode:
Heating corresponds to the set heating time
▪ Durable heat:
Constant heat up to required set room temperature or to the
calculated feed flow target temperature
▪ Durable kneeling:
Always heat to the kneeling temperature or during the kneeling time
to the calculated flow must temperature
▪ Remote control mode:
Mode according to the setting of the remote control
Indicates the flow temperature of chosen heating circuit
Indicates the back flow temperature of chosen heating circuit
Display of the actual outside temperature
Setting up required room temperature (15-30).
The correction is a factor for influencing or correction of the flow must
temperature:
This value (-5 to +5) gets multiplied by 2 and added to the flow set
temperature
Indicates the switching temperature (= average daytime temperature). In
general the switching temperature conduces to switch between winter set
temperature and summer set temperature.
Indicates the state of the heating circuit mixer (OPEN/CLOSE)
Indicates the state of the heating circuit pump (ON/OFF)
Display of the respective screed day (only if screed drying is set)
▪ OFF: The heating system is switched off
▪ Heating time mode: Heating corresponds to the set heating time
▪ Durable heat: Constant heat up to required set room temperature or to
the calculated feed flow target temperature.
▪ Durable kneeling: Always heat to the kneeling temperature or during
the kneeling time to the calculated flow must temperature.
▪ Flow fixed: During the set heating times the set flow fixed temperature
is kept constant.
▪ Remote control: Mode according to the setting of the remote control.
▪ Screed drying: Mode of screed drying. The operation of the screed
drying is described below
To Next Page
