Hettich MIKRO 200 - Querying system information; Audible signal settings

AB2400en_SARev.: 03 / 11.2023
30 / 40
Software operation
5. Turn to the right with the [Rotary knob] .
🡆 ‘ROTORCHG1’ is displayed.
Internal operating hour of the last rotor change
6. Turn to the right with the [Rotary knob] .
🡆 ‘ROTORCHG2’ is displayed.
Internal operating hour of the penultimate rotor change
7. Turn to the right with the [Rotary knob] .
🡆 ‘OPhoursCHG’ is displayed.
Internal operating hour of the last operating hours change
8. Turn to the right with the [Rotary knob] .
🡆 ‘IMBALCHG’ is displayed.
Internal operating hour of the last imbalance cut-off change
9. Turn to the right with the [Rotary knob] .
🡆 ‘OffsetCHG’ is displayed.
Internal operating hour of the last offset adjustment
10. Press the STOP/OPEN button to exit the menu.
7.4.2
Querying operating hours
The rotor is stationary.
1. Press and hold the [SELECT] button.
🡆 ‘SOUND/BELL’ is displayed after 8 seconds.
2. Press the [SELECT] button repeatedly until ‘CONTROL:’ is displayed.
🡆 ‘CONTROL:’ and the operating hours are displayed.
3. Press the [STOP/OPEN] button to exit the menu.
7.4.3
Audible signal
7.4.3.1
General
The audible signal sounds:
■ after a problem occurs in the 2s interval.
■ after completion of the centrifugation run and rotor standstill in the 30 s
interval.
Opening the lid or pressing any button stops the audible signal.
7.4.3.2
Setting an audible signal
1.
Press and hold the [SELECT] button.
🡆
‘SOUND / BELL ON’ or ‘SOUND / BELL OFF’ is displayed after 8
seconds.
2.
Use [Rotary knob] to set ‘OFF’ or ‘ON’ .
OFF = audible signal disabled
ON = audible signal enabled
3.
Press the [START/IMPULS] button.
🡆
The setting is stored.
‘*** ok ***’ is displayed briey.