Hettich MIKRO 200 - Cleaning and care; Overview of cleaning and care tasks; Cleaning and disinfection instructions

31 / 40
Rev.: 03 / 11.2023
AB2400en_SA
Cleaning and care
8 Cleaning and care
8.1
Overview table
Chap. Task to execute
if required
daily
weekly
Annually
Page
8 Cleaning and care     31
8.3 Cleaning     32
8.3 Cleaning the device  X   32
8.3 Cleaning the biosafety systems   X  32
8.3 Cleaning the accessories   X  32
8.4 Disinfection     32
8.4 Disinfecting the device X    33
8.4 Disinfecting the accessories X    33
8.5 Maintenance     33
8.5 Greasing the rubber seal of the centrifuging
chamber
  X  33
8.5 Greasing the rubber seal of the biosafety system   X  33
8.5 Checking the accessories   X  34
8.5 Checking the biosafety system   X  34
8.5 Inspecting the centrifuging chamber for damage    X 34
8.5 Greasing the motor shaft    X 34
8.5 Accessories with a limited service life X    34
8.5 Replacing centrifuge tubes X    34
8.2
Cleaning and disinfection instructions
DANGER
Risk of contamination for the user due to inadequate
cleaning or failure to observe the cleaning instructions.
− Observe cleaning instructions.
− Wear personal protective equipment when cleaning the
device.
− Observe laboratory regulations (e.g. TRBAs, the German
Protection against Infection Act, hygiene plan) for han-
dling biological agents.