Installing the Batteries
Insert the battery pack with the negative terminal facing the spring, two AA batteries per side, so that all
six chambers of the battery holder are filled (Figure1 and 2 below). Caution that the positive and negative
positions are marked on the top of the battery assembly (Figure 3). Double check that batteries make
complete contact with each other and the springs; adjust as necessary. For more information click here.
Figure 1 Figure 2 Figure 3
Remove the battery door on the bottom of the Pb200i. Slide the battery wedge to the side. Insert the
battery holder with the arrow facing the front of the instrument (Figure4). Apply slight upward force to seat
the battery holder properly; when fully inserted the battery pack should sit firmly against the battery ledge
(Figure 5). Secure the battery holder in place with the battery wedge. Replace the battery door (Figure6).
The latching mechanism will click when the battery pack is seated properly.
Caution: inserting the battery holder with the incorrect orientation will not damage the Pb200i, but the
instrument will not turn on.
Figure 4 Figure 5 Figure 6
Top; this end goes in first.
To Next Page
Loading...