eRMC cli> test upi
Recable and run the utility again if necessary.
4. Power on the system to the UEFI Shell.
eRMC cli> power on npar bootopt=uefishell
5. To confirm that there are no CRC errors or dropped lanes, run test upi again.
eRMC cli> test upi
6. Check the status of the system hardware.
eRMC cli> show health
7. Boot the operating system.
8. Verify that the replaced hardware is available.
linux# topology --io
linux# lspci
TIP: To exclude Intel Corporation entries, use: lspci | grep -v Intel
GPU card replacement 45
To Next Page
