34
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following
two conditions:
1. This device may not cause harmful
interference, and
2. This device must accept any interference
received, including interference that may
cause undesired operation.
Note: This device has been tested and found
to comply with the limits for Class B digital
devices pursuant to Part 15 Subpart B, of the
FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential environment. This
equipment generates, uses, and can radiate
radio frequency energy, and if not installed and
FCC Information
used in accordance with the instruction
manual, may cause harmful interference to
radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or
television reception, which can be determined
by turning the equipment off and on, the user is
encouraged to try and correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
To comply with the FCC’s RF exposure limits for
general population/uncontrolled exposure, this
transmitter must be installed to provide a
separation distance of at least 20cm from all
persons and must not be co-located or
operating in conjunction with any other antenna
or transmitter.
To Next Page
Loading...