62 September 2017
Printer Preferences PLT-03159, Rev A.0
4.8.1.1 Method for Defining a Single Area
1. On the Overlay / Print Area or K Panel Resin tab, select Defined Area(s).
2. Print a card and look at it in the same orientation as when it exits the printer.
3. Measure the total size of the area and enter the dimensions into the dimension boxes.
4. Measure from the lower-left corner of the card to the lower-left corner of the defined area and
enter the values into the X and Y boxes.
4.8.1.2 Method for Defining Multiple Areas
1. On the Overlay / Print Area or K Panel Resin tab, select Defined Area(s).
2. Print a card with a defined area and look at it in the same orientation as when it exits the printer.
3. Measure the defined area location based on the printed card.
4. To define another area, click the Defined Area up arrow.
5. Use the Defined Area arrows to navigate back and forth from area to area.
To Next Page
Loading...
