© 2010 HID Global Corporation All rights reserved
Configuring Fluorescent Data (F-Panel for YMCFKO Ribbon) using the Application
Step Procedure
6 Set up the Printer Driver preferences. Refer to Step 8-10 below.
7 Printer will print the fluorescent BMP IMAGE at the ~I position on the card.
Printer will print the fluorescent TEXT at the ~T position on the card. (See
Display B below)
BMP Image located at c:\globe.bmp
8 Set the Ribbon for YMCFKO in the Printing Preferences. (Note: The Detect
Supplies at Print Time button may also be used.)
9 Check Dual Pass if you would like to print the F-Panel on a separate panel of
HDP film from the YMC image.
You should use:
The default Dual Pass option if the fluorescent image is used in places where
other dye is used.
OR
Any time the Invert F-Panel Image option is selected.
DTC4500 Card Printer/Encoder User Guide
74
To Next Page
Loading...
