HID Fargo DTC4500 - Page 79

© 2010 HID Global Corporation All rights reserved
Printer Error Button and Display Message Table
Both the DTC4500 use the Button messages rather than the Display Message system.
Step Procedure
5 Press the ON/Off button when Printer is in an error state to cause the action to
be cancelled. (Note: If no other error occurs, then the Pause button will
illuminate its blue LED.)
6
Press the Pause button when Printer is in an error state to cause the Printer to
retry. (Note: It will illuminate its blue LED and retry the failed action.)
7
When downloading an upgrade file, both blue LED’s will blink. If the unit is a
DTC1000:
• You have been advised that the upgrade is in process.
8
If a language (other then English) is currently selected:
• You can press and hold the Pause button during the power-up sequence to
change the language back to English.
9
When no LCD Display is available, press or hold the buttons to access certain
Internal Test jobs. See below.
• To print a card with the Printer Settings, press the Pause button and hold for
4+ seconds when the Printer is ready and idle.
• To print the alignment or the Self Test, press the ON/OFF button then
immediately press the Pause button.
DTC4500 Card Printer/Encoder User Guide
79