Maintenance
could
cause leakage
or
damage.
翻腾翻
Change the engine
oil
after
the
first
10
hours
of
operation, and every 100
hours
or
at
6-month intervals thereafter. Other-
wise the engine
will
wear quickly.
NOTE:
Change the engine oil when
th
e oil is still
war
m.
1.
Put the outboard motor in an upright po-
sition (not tilted).
2.
Prepare a suitable container that holds a
larger amount than the engine oil capac-
ity. Loosen and remove the drain screw
while holding the container under the
drain hole. Then remove the oil liller cap.
Let the oil drain completely. Wipe up any
spilled
oil
immediately.
37
1ν
〈\
1 .
Drain
sc
r
ew
3.
Put a new gasket on the oil drain screw
Apply a light coat
01
oil to the gasket and
install the drain screw.
Drain screw tightening torque
28.0
Nm
(20.7 It-Ib) (2.86 kgl-m)
NOTE:
1I
a torque wrench is not available when you
are installing the
dr
ain screw, linger tighten
the screw just until the gasket comes into
contact with the surface
01
the drain hole.
Then tighten 1/4 to 1/2 turn mor
e.
Tighten
the drain screw to the correct torque with a
torque w
ren
ch as soon as
possib
怡，
4. Add
th
e correct amount
01
oil through the
liller hole. Install the liller cap.
Reco
mm
end
ed
engine oil:
4-stroke outboard motor oil
Engine oil quantity (excluding oil lilter)
1.7 L
(1
.80
US
qt) (1.50
Imp
叩)
1
1.
Oil
Iiller
cap
5. Start the engine and watch to make s
ur
e
the low oil pressure warning indicat
or
(
il
equipped) turns
0
仔.
Make sure
th
at
there are no oil leaks.
If
the
low
011
pressure
warning
indicat
or
does
not
turn
0
衍。
r
If
th
ere
are
oil
leaks
,
stop
the
engine
and
find
the
cause. Con-
tlnued operatlon
wlth
a problem c
ould
cause severe
englne
damage.
Consult
your
dealer
if
the
problem
can
not
be
located and corrected.
6.
Turn
0
何
the
engine and wait 3 minutes.
Recheck the oil level using the dipstick
to be sure the level falls between the up-
per and lower marks. Fill with oil
il
it is
below the lower mark, or drain to the
specified level if it is abo
ve
the upper
mark.
Maintenance
7.
Dispose
of
used oil according to local
regulations.
NOTE:
• For more information on the disposal of
used oil, consult your dealer.
• Change the oil more often when operating
th
e engine under adverse conditions such
as extended trolling
Checklng
wiring
and
connectors
• Check that each grounding wire
is
properly
secured.
I
• Check that each
conn
田
tor
ís
engaged se-
curely.
Exhaust
leakage
Start the engine and check that
no
exhaust
leaks from the joints between the exhaust
cover
, cylinder head, and body cylinder.
38
To Next Page
Loading...
Need help?
General
