18
MECHANICAL INSTALLATION
INSTALLATION INSTRUCTIONS
Before you start with the installation of the sound system, disconnect necessarily the GROUND connection wire from the
battery to avoid any risk of electric shocks and short circuits.
Avoid any damages on the components of the vehicle like air bags, cables, board computer, seat belts, gastank or the like.
Ensure that the chosen location provides a sufcient air circulation for the amplier. Do not mount the device into small or sealed spaces
without air circulation near by heat dispersing parts or electrical parts of the vehicle.
Do not mount the amplier on top of a subwooferbox or any other vibrating parts, whereby parts could loosen inside.
The wires and cables of power supply and the audio signal must be as short as possible to avoid any losses and interferences.
At rst you need to nd a suitable installation location for
the amplier. Ensure that enough space for the installati-
on of the cables remains and that they will not be bended
and have sufcient pull relief.
Lay the amplier aside and then drill the holes for the
mounting screws at the marked locations.
Please ensure not to damage any components of the ve-
hicle while you drilling the holes. Alternatively (depends
on the material of the surface) you can also use self-tap-
ping screws.
Keep the amplier at the chosen mounting location in the
vehicle. Then mark the four drill holes with an appropria-
te pen or peening tool through the designated mounting
holes at the amplier.
Then uphold the amplier to the chosen position and x
the screws through the mounting holes into the drilled
screwholes.
Ensure that the mounted amplier is tightly xed and can
not come loose while driving.
NOTE
1
4 x
4 x
4 x
4 x
3
2
4
Drill
Mounting hole
Mounting hole
Marking
Pen or
peening
tool
Mounting
screw
To Next Page
Loading...
Need help?
General