Hifonics Atlas Series User Manual

20
FUNCTIONAL INSTRUCTIONS
FEATURES AND OPERATIONAL CONTROLS
1
The LINE IN & SUB IN RCA jacks must be connected with the RCA output jacks of the headunit.
Please check also the notes in section #15 on the right.
1 10 11 12 13 14 15 16
POWER INPUT
FUSE
SPEAKER OUTPUT
BRIDGED
PROTECT
POWER
LP/BPFULLHP
HP/BP LP
CH2CH1
LEVEL
INPUT
X-OVER
CH3/CH4
50Hz 250Hz 150Hz 4kHz
GND +12VREM
5CH
2CH
INPUT MODE
BRIDGED
CH4CH3
ARX5005
LEVEL
MIN MAX
FULLHP
X-OVER
CH1/CH2
HP
50Hz 4kHz
LEVEL
MIN MAX
MIN MAX15Hz 55Hz 0dB 18dB
SUB OUTPUT
4CH
35Hz 150Hz
HI
LOW
OFF
ON
CH3
CH4
CH1
CH2
CH5
BASS LEVEL
CONTROLLER
CH5
LEVELSUB SONIC BASS BOOST CH5LP
AUTO TURN ON
(ONLY IN HI LEVEL INPUT MODE)
LINE IN SUB IN
BLUE / WHITE
LOG0
2 3 4 5 6 7 8 9
2
SPEAKER CABLES
SHIELD
TO THE LINE IN ON THE
AMPLIFIER
CORE CONDUCTOR
HI LEVEL INPUTS & AUTO TURN ON
If your head unit has no pre-amplier low level RCA outputs or doesn’t provide a separate remote turn on wire (like described on
page 19/#2), follow these instructions:
AUTO TURN ON
Bring the AUTO TURN ON switch to position ON to activate the auto turn on function. This function only works, if the push button
INPUT LEVEL MODE is in HI position, the switch INPUT MODE in 2CH position and highlevel inputs (speaker outputs from the
headunit) are connected at the LINE IN CH1 & CH2. Please check the regarding notes below.
The amplier detects now by the so called ”DC Offset” (a voltage increase to 6 volts on the high level speaker outputs) if the
head unit is turned on and the amplier turns automatically on. As soon as the head unit is turned off, the amplier shuts down
automatically after approx.one minute.
NOTE: The AUTO TURN ON usually works with 90% of all headunits, because they are equipped with the ”High Power” outputs.
Only with a few older headunits the AUTO TURN ON function is not applicable.
The port of the remote connector of the amplier (page 19#2, REM) can now be used also to turn on additional other ampliers.
Connect the REM ports of the ampliers and ensure, that the other amplier’s AUTO TURN ON function is deactivated.
High level speaker cables as signal input:
Please use the optional HF-HLA adaptor from HiFonics (see
page 28). This adaptor is optmized for the use with this amplier
inputs and owns additionally a protect function for the speaker
outputs of your headunit.
Alternative: Solder the ends of the loudspeaker cables of the
head unit with common RCA connectors (separately available)
and connect them with LINE IN of the amplier.
The HI LEVEL INPUTS can be use independently from the
AUTO TURN ON function.

Hifonics Atlas Series Specifications

General

Brand	Hifonics
Model	Atlas Series
Category	Amplifier
Language	English