11
Supercell can be charged using two methods:
• using the wall charger connected to the 120V/240V wall power, or a 120V/240V vehicle
mounted inverter.
• using the +12V dc charger cord, connected to a 12V vehicle auxiliary socket.
Wall Charger
1. Make sure Supercell is turned o, (hold the red stop buon in for 3 seconds to power o
the machine).
2. Plug the charger into the wall and power it on. The green light will ash once per sec-
ond.
3. Plug the charger output into the charging socket of Supercell.
4. The charger’s indicator light will turn solid red, and the baery pack will start to charge.
5. The baery pack will charge from 0% to 100% in approximately 90 minutes (on 120V).
When charging is complete, the charger’s indicator light will turn solid green.
6. Power o the charger and unplug it. CAUTION: the charger will become hot with extend-
ed use.
7. If the charger’s indicator light ashes red while charging, then there is a fault with either
the charger or Supercell. Contact your distributor for help.
8. If the baery pack exceeds 113°F while charging, Supercell will detect this and halt
charging, and the light will go solid green. This will happen even if the baery pack is not
completely charged. Turn Supercell on and check the charge percentage to make sure
the charge completed.
+12V Auxiliary charger.
1. Make sure Supercell is turned o, (hold the red stop buon in for 3 seconds to power o
the machine).
2. Plug the charger cord into the 12V auxiliary socket of the vehicle.
3. Plug the charger into the charging socket of Supercell.
4. The baery pack will start to charge. There is no indicaon of charge.
5. The baery pack will charge from 0% to 100% in approximately six hours.
6. To check the state of charge of the baery pack, turn Supercell on and check the baery
percentage. If it is not fully charged turn Supercell o to resume charging.
To Next Page
Loading...