Highland Supercell - Delivered Items; Intended Use; Introduction

5
DELIVERED ITEMS
Carefully remove the welding processor from its packaging and check that you have the follow-
ing items:
• Welding processor.
• Wireless bar code scanner.
• Mains powered baery charger.
• +12V dc car charging lead.
• USB memory drive.
Note: to download a copy of this manual, visit www.supercellef.com
INTENDED USE
This equipment is intended to fuse constant voltage electrofusion ngs suitable for low, me-
dium, and high-pressure pipe work systems, up to a maximum diameter of 14 inch (355mm).
This welding processor has been designed to comply with the Internaonal Organizaon for
Standardizaon standard ISO12176-2:2000 “Plasc pipes and ngs, equipment for fusion
joinng polyethylene systems, part 2, electrofusion”.
INTRODUCTION
This manual gives instrucons on the correct assembly and safe use of your electrofusion pro-
cessor. It is important that you read these instrucons and always keep these instrucons with
the unit.
This manual does not detail the specic welding procedure for the ngs: peeling, clamping
and assembly of joints. For this informaon, please contact the ngs manufacturer or refer
to your organizaon’s internal procedures.