29
HARDWARE RESET
Because this machine is baery powered, if things go wrong, it is not possible to do a hardware
reset by unplugging it from the mains supply. In case this happens, a reset fuse is provided.
RESET FUSE.
If the machine soware locks-up and it cannot be turned o by pressing any of the buons,
the reset fuse can be removed.
Carefully unscrew the fuse and remove it for around ten seconds. Replace the fuse and the
machine will restart.
Warning: Only remove the fuse if the machine has locked up. Do not remove it while weld-
ing.
To Next Page
Loading...