Hikmicro CHEETAH LRF Series User Manual

Digital Night Vision Monocular User Manual
6
When the battery is sufficiently charged, hold for about 2 seconds to power on the device.
Power Off
When the device is turned on, hold for 2 seconds to power off the device.
Auto Power Off
Set the auto power off time for your device, and then the device will automatically shut down as
the set time.
Steps
1. Hold the wheel to go to the menu.
2. Rotate the wheel to select , and press the wheel to select the auto power off time as
required.
3. Hold the wheel to save and exit.
Note
● See the battery icon for the battery status. means the battery is fully charged, and
means that the battery is low.
● When the low power note shows, charge the battery.
● The auto power off countdown will start again when the device exits standby mode, or the
device is restarted.
2.7 Menu Description
When the device is turned on, hold the wheel to show the menu.
In the menu, you can rotate the wheel to select functions, press the wheel to configure the
selected function, and hold the wheel to exit the menu.
Figure 2-7 Menu Interface

Hikmicro CHEETAH LRF Series Specifications

General

Sensor Resolution	384 × 288
Display Resolution	1024 × 768
Detection Range	1800 m
Laser Rangefinder	Yes
Waterproof Rating	IP67
Frame Rate	50 Hz
Pixel Interval	12 μm
Laser Rangefinder Accuracy	± 1 m
Protection Level	IP67
Eye Relief	15 mm
Display	OLED