Hikmicro Pocket Series User Manual

Pocket Series User Manual
x
Safety Instruction
These instructions are intended to ensure that user can use the product
correctly to avoid danger or property loss. Please read all the safety
information carefully before using.
Laws and Regulations
● Use of the product must be in strict compliance with the local electrical
safety regulations.
Transportation
● Keep the device in original or similar packaging while transporting it.
● Keep all wrappers after unpacking them for future use. In case of any
failure occurred, you need to return the device to the factory with the
original wrapper. Transportation without the original wrapper may
result in damage on the device and the company shall not take any
responsibilities.
● DO NOT drop the product or subject it to physical shock. Keep the
device away from magnetic interference.
Power Supply
● Input voltage should meet the Limited Power Source (3.85 VDC, 570
mA) according to the IEC62368 standard. Please refer to technical
specifications for detailed information.
● Make sure the plug is properly connected to the power socket.
● DO NOT connect multiple devices to one power adapter, to avoid over-
heating or fire hazards caused by overload.
● Use the power adapter provided by a qualified manufacturer. Refer to
the product specification for detailed power requirements.
Battery
● Improper use or replacement of the battery may result in explosion
hazard. Replace with the same or equivalent type only. Dispose of used

Hikmicro Pocket Series Specifications

General

Wi-Fi	Yes
Laser Pointer	Yes
Accuracy	±2°C or ±2%
Image Modes	Thermal, PIP
Battery Type	Li-ion Battery
Sensor Type	Uncooled VOx microbolometer
Spectral Range	8 to 14 μm
Resolution	384 × 288 (Pocket2)