Pocket Series User Manual
15
alarm.
Steps
1. Go to Settings → Measurement Settings → Alarm Settings.
2. Enable Temperature Alarm and set the alarm parameters.
Alarm Threshold
When the tested temperature exceeds the threshold, the device
sends alarm notification to the client software. The device will buzz if
the audible warning is enabled, and the flashlight will flash if the
flashing alarm is enabled.
Alarm Linkage
● Audible Warning: The device beeps when target temperature
exceeds the alarm threshold.
● Flashing Alarm: The flash light flashes when target temperature
exceeds the alarm threshold.
4. Tap to save and exit.
To Next Page
Loading...
