Thermal Image Scope User Manual
4
Figure 2-2 Loosen the Cover
2. Insert the battery into the battery compartment with the positive mark inward.
Figure 2-3 Install the Battery
3. Turn the battery cover clockwise to tighten it.
Figure 2-4 Tighten the Cover
Note
Remove the battery if the device is not used for a long time.
2.3 Power On/Off
Power On
When the battery is sufficiently charged, press to power on the device.
Power Off
When the device is turned on, hold for 2 seconds to power off the device.
Note
● Power-off countdown will appear when you power off the device. You can press any key to
interrupt the countdown and cancel the power-off.
● Automatic low battery power-off cannot be canceled.
To Next Page
Loading...
