Hikmicro STELLAR Series User Manual

Thermal Image Scope User Manual
6
record video, or configure parameters on your phone.
Steps
1. Hold the wheel to show the menu of device.
2. Press to enable hotspot function.
3. Turn on the WLAN of your phone and connect to the hotspot.
● Hotspot Name: HIK-IPTS Serial No.
● Hotspot Password: Serial No.
4. Search the HIKMICRO Sight app on App Store (iOS System) or Google Play™ (Android System) to
download it, or scan the QR code to download and install the app.
Android System
iOS System
5. Open the app and connect your phone with the device. You can view the interface of device on
your phone.
Note
● The device cannot connect to the App if entering wrong password several times. Refer to
Restore Device to reset the device, and connect the app again.
● The device should be activated for the first use. The default password must be changed after
the activation.
2.5.2 Check Firmware Status
Steps
1. Open the HIKMICRO Sight and connect your device to the app.
2. Check if there is a red spot on the connection interface. If there is no red spot, the firmware is
the latest version. Otherwise, the firmware is not the latest version.
Figure 2-6 Check Firmware Status

Hikmicro STELLAR Series Specifications

General

Pixel Size	12 μm
Frame Rate	50 Hz
Wi-Fi	Yes
Video Recording	Yes
Photo Capture	Yes
Resolution	384x288, 640x512
Display	AMOLED
Battery Type	Rechargeable Li-ion
Operating Temperature	-20°C to +50°C
Lens Options	19mm, 25mm, 35mm, 50mm
Focus	Manual
Color Palettes	Black Hot, White Hot, Red Hot, Fusion