HD-TVI Speed Dome DS-2AE7232TI-A User Manual
UM THD DS-2AE7232T-x 020519NA 18
Protocol and RS-485 Settings
1. Select the protocol. Set the protocol on the PROTOCOL submenu to AUTO MATCH, PELCO-P, PELCO-D, or
HIKVISION. AUTO MATCH is protocol self-adaptive.
2. Set the protocol status. Set the PROTOCOL STATUS to ON to enable the user-defined protocol.
3. Enable the RS-485 configuration diagnosis. You can set 485 CHECK to ON or AUTO for automatic RS-485
configuration diagnosis. If the configuration is incorrect, an alert will be received. If you set the value
to AUTO, it will automatically stop the diagnosis when no errors exist.
Power Memory Settings
The dome can resume its previous PTZ status after it restarts from power off when it stops at a position
longer than the predefined time. You can set the memory time to 10s, 30s, 60s, 180s, and 300s.
Hikvision-C (Coaxitron) Control
The Coaxial Transmission function can be enabled to transmit the RS-485 signal along with the video
signal via the BNC cable. If the connected encoding device supports coaxial transmission as well, the RS-
485 cable will not be necessary.
1. Enable the Coaxial Control function by setting the COAXITRON ACTIVE option to ON.
2. Select the Coaxial Control protocol to HIK-C.
NOTE: Set the transmission protocol of the connected encoding device to the same value as the
speed dome to support the coaxial transmission.
Configuring Image Parameters
Configuring Camera Parameters
Purpose:
You can set the camera parameters including focus, shutter speed, iris, etc. Enter the camera parameters
settings menu: MAIN MENUS > DOME SETTINGS > CAMERA PARAMETER.
To Next Page
Loading...
