Network Cube Camera·Quick Start Guide
Steps:
1. Access the camera via web browser. Refer to Chapter 5.
2. Enter platform access configuration interface: Configuration >
Network > Advanced Settings > Platform Access
Platform Access Configuration (Web) Figure 6-2
3. Select Platform Access Mode as Hik-Connect.
4. Check the checkbox of Enable.
5. Click and read "Terms of Service" and "Privacy Policy" in pop-up
window.
6. Create a verification code or change the verification code for the
camera.
Note:
The verification code is required when you add the camera to
Hik-Connect app.
7. Save the settings.
To Next Page
Loading...
