User Manual of Network Camera
70
(5) Slide the cursor to adjust the sensitivity and proportion of object on the area for the
selected area in the daytime.
(6) Slide the cursor to adjust the sensitivity and proportion of object on the area for the
selected area at night.
(7) Set the arming schedule and linkage method as in the normal configuration mode.
(8) Click Save to save the settings.
6.6.2 Configuring Video Tampering Alarm
Purpose:
You can configure the camera to trigger the alarm when the lens is covered and take
alarm response action.
Steps:
1. Enter the video tampering Settings interface:
Configuration > Advanced Configuration > Events > Video Tampering
Figure 6-41 Video Tampering Alarm
2. Check Enable Video Tampering checkbox to enable the video tampering
detection.
3. Set the video tampering area; refer to Task 1 Set the Motion Detection Area in
To Next Page
Loading...
