User Manual of E Series Network Mini PTZ camera
© Hikvision
Figure 5-2 Record Parameters
Pre-record: The time you set to start recording before the scheduled time or the event.
For example, if an alarm triggers recording at 10:00, and the pre-record time is set as 5
seconds, the mini PTZ camera starts to record at 9:59:55.
The Pre-record time can be configured as No Pre-record, 5 s, 10 s, 15 s, 20 s, 25 s, 30 s or
not limited.
The pre-record time changes according to the video bitrate.
Post-record: The time you set to stop recording after the scheduled time or the event.
For example, if an alarm triggered recording ends at 11:00, and the post-record time is
set as 5 seconds, the mini PTZ camera records until 11:00:05.
The Post-record time can be configured as 5 s, 10 s, 30 s, 1 min, 2 min, 5 min or 10 min.
Overwrite: If you enable his function and the HDD is full, the new record files overwrite
the oldest record files automatically.
Recording Stream: You can select the stream type for recording; Main stream and Sub
Stream are selectable. If you select the sub stream, you can record for a longer time with
the same storage capacity.
The Pre-record and Post-record parameters vary depending on the mini PTZ camera
model.
4. Click OK to save the advanced setting.
To Next Page
Loading...
