User Manual of E Series Network Mini PTZ camera
© Hikvision
defined by a preset to another, without showing the middle areas between these two, to
ensure the surveillance efficiency. It can also reduce the use of bandwidth in a digital
network system.
Preset freezing function is invalid when you calling a pattern.
Preset Speed: You can set the speed of a defined preset from 1 to 8.
Keyboard Control Speed: Define the speed of PTZ control by a keyboard as Low, Normal
or High.
Auto Scan Speed: The mini PTZ camera provides 5 scan modes: auto scan, tilt scan, frame
scan, random scan and panorama scan. The scan speed can be set from level 1 to 40.
Zooming Speed: The speed of zooming is adjustable.
PTZ OSD: Set the on-screen display duration of the PTZ status.
Zoom Status: Set the OSD duration of zooming status as 2 seconds, 5 seconds, 10
seconds, Always Close or Always Open.
PT Status: Set the azimuth angle display duration while panning and tilting as 2 seconds,
5 seconds, 10 seconds, Always Close or Always Open.
Position Display Format: Set the position display format as PT or Direction and the
position parameter displays in corresponding format.
Preset Status: Set the preset name display duration while calling the preset as 2 seconds,
5 seconds, 10 seconds, Always Close or Always Open.
Power-off Memory: The mini PTZ camera can resume its previous PTZ status or actions after
it restarted from a power-off. You can set the time point of which the mini PTZ camera
resumes its PTZ status. You can set it to resume the status of 30 seconds, 60 seconds, 300
seconds or 600 seconds before power-off.
3. Click to save the settings.
5.4.2 Configuring PTZ Limits
Purpose:
The mini PTZ camera can be programmed to move within the configurable PTZ limits (left/right,
up/down).
Steps:
1. Enter the Limit Configuration interface:
Configuration > PTZ > Limit
To Next Page
Loading...
