HIKVISION DS-2DP0818ZIX - Chapter 2 Setting Local Parameters and Network; Configuring Local Parameters

User Manual of PanoVu Series Network Camera
12
Chapter 2 Setting Local Parameters and
Network
2.1 Configuring Local Parameters
Note:
The local configuration refers to the parameters of the live view and other operations using the web
browser.
Steps:
1. Enter the Local configuration interface:
Configuration > Local
Figure 2-1 Local Configuration Interface
2. Configure the following settings:
 Live View Parameters: Set the protocol type, play performance, rules, and image format.
 Protocol: TCP, UDP, MULTICAST and HTTP are selectable.
TCP: Ensures complete delivery of streaming data and better video quality, yet the real-time
transmission will be affected.
UDP: Provides real-time audio and video streams.
MULTICAST: It’s recommended to select the protocol type to Multicast when using the Multicast
function. For other information about Multicast, refer to Section 2.2.1 Basic Settings -
Configuring TCP/IP Settings.
HTTP: Allows the same quality as of TCP without setting specific ports for streaming under some
network environments.
 Play Performance: Set the live view performance to Shortest Delay, Balanced or Fluent.
 Rules: You can enable or disable the rules of dynamic analysis for events here.