Steps:
1. Enter the Maintenance interface:
Configuration >System > Maintenance > Upgrade & Maintenance
2. Select Firmware or Firmware Directory.
Firmware: when you select Firmware, you need to find the firmware in your computer
to upgrade the device.
Firmware Directory: You need to find the directory where the firmware locates. The
device can find the firmware in the directory automatically.
3. Click to select the local upgrade file and then click to start
remote upgrade.
The upgrading process will take 1 to 10 minutes. Please don't disconnect power of the
positioning system during the process. The positioning system reboots automatically after
upgrading.
Figure 7-67 Remote Upgrade
Log Searching
Purpose:
The operation, alarm, exception and information of the speed dome can be stored in log files. You
can also export the log files on your demand.
Before you start:
Please configure network storage for the speed dome or insert a memory card in the speed
dome.
Steps:
1. Enter the Log interface:
Configuration >System > Maintenance > Log
To Next Page
Loading...
