HIKVISION DS-7108NI-Q1/M

6. Set the linkage
acons. Refer to Congure Alarm Linkage Acon for details.
7. Click Apply.
Region Entrance Detecon
Region entrance detecon detects objects that enter a predened virtual region.
Steps
1. Go to
Conguraon → Camera → Event → Region Entrance .
Figure 5-12 Region Entrance Detecon
2. Select a camera.
3. Turn on Enable.
4. Set
detecon rules and detecon areas.
1) Set Arming Area. Up to 4 arming areas are selectable.
2) Set
Sensivity. The higher the value is, the easier the detecon alarm can be triggered. Its
range is [1-100].
3)
Oponal: Set Target Detecon as Human or Vehicle to discard alarms which are not
triggered by human body or vehicle.
4) Click Draw Area to draw a quadrilateral
detecon region.
5. Set the arming schedule. Refer to for Congure Arming Schedule for details.
6. Set the linkage acons. Refer to Congure Alarm Linkage Acon for details.
7. Click Apply.
Region
Exing Detecon
Region exing detecon detects objects that exit from a predened virtual region.
Steps
1. Go to
Conguraon → Camera → Event → Region Exing .
Network Video Recorder User Manual
28