HIKVISION DS-7108NI-Q1/M User Manual

Figure 5-14 Set Arming Schedule
3. Click Apply.
Congure
Alarm Linkage Acon
Alarm linkage acons will be acvated when an alarm or excepon occurs.
Steps
1. Click Linkage
Acon.
Figure 5-15 Linkage Acons
2.
Set normal linkage acons, alarm output linkage acons, trigger channel, etc.
Alarm Pop-up Window
The local monitor will pop up the alarming channel image when an alarm is triggered. It
requires to select the alarming channel(s) in Trigger Channel.
Buzzer Alarm
It will trigger a buzzer beep when an alarm is triggered.
Nofy Surveillance Center
The device will send an excepon or alarm signal to the remote client soware when an
alarm is triggered.
Send Email
It will send an email with alarm
informaon when an alarm is triggered.
PTZ Linkage
It will trigger PTZ acons (e.g., call preset/patrol/paern) when smart events occur.
3. Click Apply.
Network Video Recorder User Manual
30

HIKVISION DS-7108NI-Q1/M Specifications

General

DC voltage	12 V
Power supply type	DC
Power consumption (typical)	10 W
Operating temperature (T-T)	-10 - 55 °C
Operating relative humidity (H-H)	10 - 90 %
Video input channels	8 channels
USB 2.0 ports quantity	2
VGA (D-Sub) output ports	1
Supported network protocols	TCP/IP, DHCP, Hik-Connect, DNS, DDNS, NTP, SADP, SMTP, UPnP
Ethernet LAN	Yes
Ethernet interface type	Fast Ethernet
Maximum HDD capacity	6000 GB
Video compression formats	H.264, H.265

Weight and Dimensions

Depth	225 mm
Width	260 mm
Height	48 mm
Weight	1000 g