User Manual of DS-7200-ST Series DVR
36
Starting and Shutting Down Your DVR
Proper startup and shutdown procedures are crucial to expand the life of your DVR.
To start your DVR:
1. Please make sure the input voltage meets the requirements of DVR, and the GND is in grounding.
2. Please make sure the VGA port on its rear panel has connected with a display device or the VIDEO OUT
port has connected to a monitor, or else no prompt message will be displayed on screen after device startup
and the menu operation is inaccessible as well.
3. In case the POWER indicator on the front panel does not light, please apply power to the device to start it.
After the power has been started up, the POWER indicator will light green, and the startup window will appear:
To shut down the DVR:
1. Enter the Shut Down menu, shown in Figure 1 by clicking on Menu > ShutDown.
Figure 1. Shutdown Menu
2. Select the ShutDown button.
3. Click the Yes button in the pop-up attention box to confirm the shutdown.
4. For the DS-7200HVI-ST/SN and DS-7200HFI-ST/SN models, you are allowed to power off the
unit only when the following interface appears:
Figure 2. Shutdown
Rebooting and Locking Your DVR
While in the Shutdown menu (Figure 1), you may also reboot or lock your DVR. Locking your DVR will return
you to the Live View mode, which will require a user name and password to exit out of it. The Reboot button will
reboot your DVR.
To reboot or lock your DVR:
1. Enter the Shutdown menu by clicking Menu > ShutDown.
2. Select the Lock button to lock the DVR or the Reboot button to reboot the DVR.
To Next Page
Loading...
Need help?
General