User Manual of DS-7200-ST Series DVR
73
7. User may select the PTZ camera to link with the alarm input and then set the callup of preset,
patrol and pattern for alarm linked actions.
8. Click the OK button to complete setup.
You may now add a schedule to start recording when an alarm is triggered (See Scheduling a Recording).
Alarm outputs may also be configured in the Alarm Management menu. To set up Alarm Output:
1. Select the Alarm Output tab. This will bring up the Alarm Output interface, shown in Figure 11.
Figure 11. Alarm Output Interface
2. Select the output you would like to configure and click the Set button. This will bring up the
settings page for the selected channel (Figure 12).
Figure 12. Alarm Output Settings
3. Configure the settings for selected output.
4. Select OK to save and exit.
Note: If the Hold For option is selected as Manually Stop, the alarm will only stop when you manually stop it
(See Triggering Alarm Outputs Manually).
Manual Alarm Triggering
Note: This section is invalid for DS-7200HVI-ST/SE, DS-7200HFI-ST/SE, DS-7200HVI-ST/SN and
DS-7200HFI-ST/SN models as they provide no alarm in/out.
You may also trigger alarm outputs manually through the Manual Alarm menu.
To Next Page
Loading...
Need help?
General