User Manual of DS-7200-ST Series DVR
86
Figure 10. Host/Others Menu
5. Click OK to save settings and exit the Host/Others menu.
Configuring Server and HTTP Ports
If you would like to change the server and HTTP ports from the default settings, you can do so in the Network
Settings menu. The default server port is 8000 while the default HTTP port is 80.
To change the default ports:
1. Click Menu > Settings > Network to enter the Network Settings menu.
2. Select the Advanced tab.
3. Click the Set button next to Host/Others to enter the Host/Others menu.
4. Enter new Server Port and HTTP Port, as shown in Figure 11.
Figure 11. Host/Others Menu
Note: The Server Port has a port range of 2000-65535 and is used for remote client software access. The HTTP
port is used for remote Internet browser access.
Configuring Email
The device can be configured to send an Email notification to all designated users if an alarm event is detected or a
motion detection event is detected, etc.
Before configuring the Email settings, the device must be connected to a local area network (LAN) that maintains
To Next Page
Loading...
Need help?
General