20
Figure8. Schedule Settings
18. Click Edit button to enter a new recording schedule, shown in Figure 9.
19. Check both the Enable Schedule and All Day checkbox. This will enable the recording schedule
and make it record continuously all day.
Figure9. Edit Schedule Settings
20. Click the OK button. This will take you back to the Schedule tab. To copy the schedule to a
different channel, select the channel or all under Copy To and click the Copy button.
21. Click Next button to access the Network Settings dialog box, shown in Figure 10.
Figure10. Network Settings
16. To configure network settings, click the Enter button.
17. Enter the IP Address, Subnet Mask and Default Gateway settings.
18. Click OK button to return to the Setup Wizard.
19. If all the settings have been entered, click Done to finish and exit the Setup Wizard.
You’ve completed the Setup Wizard. The next step in the initial setup process is to setup the system date and time.
To Next Page
Loading...
Need help?
General