HIKVISION DS-7732NXI-K4/16P User Manual

number varies with device models. If you disable a PoE interface, you can also use it to connect to
an online network camera.
Add PoE Camera
Steps
1.
Go to Conguraon → Camera → Camera → PoE Sengs .
2.
Enable or disable long network cable mode by selecng Long Distance or Short Distance.
Long Distance
Long-distance (100 to 300 meters) network transmissions via PoE interface.
Short Distance
Short-distance (< 100 meters) network transmission via PoE interface.
Note
●
The PoE ports are enabled with the short distance mode by default.
●
The bandwidth of IP camera connected to the PoE via long network cable (100 to 300 meters)
cannot exceed 6 Mbps.
●
The allowed max. long network cable may be less than 300 meters depending on
dierent IP
camera models and cable materials.
●
When the transmission distance reaches 100 to 250 meters, you must use the CAT5e or CAT6
network cable to connect with the PoE interface.
●
When the transmission distance reaches 250 to 300 meters, you must use the CAT6 network
cable to connect with the PoE interface.
Network Video Recorder User Manual
54

HIKVISION DS-7732NXI-K4/16P Specifications

General

Model	DS-7732NXI-K4/16P
Category	Network Hardware
Video Input Channels	32
IP Video Input	32
VGA Output Resolution	1920×1080
Decoding Format	H.265+/H.265/H.264+/H.264
Two-Way Audio	Yes
HDD Slots	16
Incoming Bandwidth	320 Mbps
Outgoing Bandwidth	160 Mbps
Alarm In/Out	16/4
PoE	Yes
Operating Humidity	10% to 90%
Operating System	Embedded LINUX
Video Output	HDMI, VGA
HDMI Output Resolution	4K (3840 × 2160)
Max Resolution	12 MP
Recording Resolution	Up to 8 MP
Audio Input	16-ch
Audio Output	1-ch (RCA)
Storage Capacity	Up to 10 TB capacity for each HDD
Network Interface	10/100/1000 Mbps
USB Interface	1 × USB 3.0
PoE Standard	IEEE 802.3af/802.3at
Power Supply	100-240 VAC, 50/60 Hz
Operating Temperature	-10°C to +55°C (14°F to 131°F)