153
User Manual of Digital Video Recorder
date/time.
Steps:
1.
Enter the Network Settings interface.
Menu > Configuration > Network
2.
Select the
NTP
tab to enter the NTP Settings interface.
Figure 9. 14 NTP Settings Interface
3.
Check the
Enable NTP
checkbox to enable this feature.
4.
Configure the following NTP settings:
•
Interval:
Time interval between the two synchronizing actions with NTP server. The unit is minute.
•
NTP Server:
IP address of NTP server.
•
NTP Port:
Port of NTP server.
5.
Click the
Apply
button to save and exit the interface.
The time synchronization interval can be set from 1 to 10080 minutes, and the default value is 60 minutes. If the
DVR is connected to a public network, you should use a NTP server that has a time synchronization function,
such as the server at the National Time Center (IP Address: 210.72.145.44). If the DVR is set in a more
customized network, NTP software can be used to establish a NTP server used for time synchronization.
9.2.4
Configuring SNMP
Purpose:
You can use SNMP protocol to get device status and parameters related information.
Steps:
1.
Enter the Network Settings interface.
Menu > Configuration > Network
2.
Select the
SNMP
tab to enter the SNMP Settings interface.
Figure 9. 15 SNMP Settings Interface
3.
Check the
Enable SNMP
checkbox to enable this feature.
4.
Configure the following SNMP settings:
•
Trap Address:
IP Address of SNMP host.
•
Trap Port:
Port of SNMP host.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
