HIKVISION DS-D5043FL-B - Configure Temperature Monitoring

Figure 2-10 Restore Defaults
2. Press ►to start
restoraon.
A dialog box pops up.
3. Press ◄ to connue restoring the defaults or ► to cancel the operaon and back to the menu.
2.6.3
Congure Temperature Monitoring
You can enable Overheat Alarm and once the board temperature is too high, an alarm prompt
appears on the screen.
Steps
1. Enter Alarm Sengs page: MENU → Alarm Sengs .
2. Press ◄or ► to enable/disable Overheat Alarm.
LCD Monitor User Manual
13