HIKVISION DS-K1T341AMF - Configure Card Reader Authentication Mode and Schedule

9.7.6 Congure Card Reader Authencaon Mode and Schedule
You can set the passing rules for the card reader of the access control device according to your
actual needs.
Steps
1. Click Access Control → Advanced Funcon → Authencaon to enter the authencaon mode
conguraon page.
2. Select a card reader on the le to congure.
3. Set card reader authencaon mode.
1) Click Conguraon.
Figure 9-12 Select Card Reader Authencaon Mode
Note
PIN refers to the PIN code set to open the door. Refer to Congure Access Control
Informaon .
2) Check the modes in the Available Mode list and they will be added to the selected modes
lis
t.
DS-K1T341A Series Face
Recognion Terminal User Manual
131