HIKVISION DS-K1T341AMF - Chapter 3 Installation; 3.1 Installation Environment; 3.2 Install with Gang Box

Chapter 3 Installaon
3.1 Installaon Environment
• Avoid backlight, direct sunlight, and indirect sunlight.
• For
beer recognion, there should be light source in or near the installaon environment.
Note
For details about installaon environment, see Tip
s for Installaon Environment.
3.2 Install with Gang Box
Steps
Note
The
addional force shall be equal to three mes the weight of the equipment. The equipment ad
its associated mounng means shall remain secure during the installaon. Aer the installaon,
the equipment, including any associated mounng plate, shall not be damaged.
1. Mak
e sure the gang box is installed on the wall.
Figure 3-1 Install Gang Box
2. Use 2 supplied scr
ews (SC-K1M4×6-SUS) to secure the base plate on the gang box.
DS-K1T341A Series Face Recognion Terminal User Manual
4