Congure Break Time
You can add break me and set start me, end me, duraon, calculaon mode and other
parameters for the break. The added break me can also be edited or deleted.
St
eps
1. Click Time & Aendance → Time
table → Break Time .
The added break me is displayed in the list.
2. Click Break Time Sengs to enter Break Time Sengs window.
3. Click Add.
4. Enter a name for the break me.
5. Set related parameters for the break me.
Start Time / End Time
Set the me when the break starts and ends.
No Earlier Than / No Later Than
Set the earliest swiping me for starng break and the latest swiping me for ending break.
Break Duraon
The duraon from start me to end me of the break.
Calculaon
Auto Deduct
The br
eak duraon will be automacally calculated as 60 minutes.
Must Check
The break
duraon will be calculated and excluded from work hours according to actual
check-in and check-out me.
Return from Break Early for
The actual check-in and check-out me does not exceed the break me, and can be
mark
ed as normal work or work overme.
Return from Break Late for
The actual check-in and check-out me exceeds the break me, and can be marked as
la
te, absent or early leave.
Calculated by
Each Check in/out: Each check-in me and check-out me is valid and the sum of all
periods between adjacent check-in and check-out me will be recorded as the break
me
duraon.
First In & Last Out: The rst check-in me is recorded as start break me and the last
check-out me is recorded as the end break me.
Enable T&A Status
DS-K1T341A Series Face Recognion Terminal User Manual
156