Note
This funcon should be supported by the device.
7. Oponal: Enable Calcula
te Break Time into Aended Duraon.
Note
When enabled, break me will be calculated into the overall aendance duraon. That is, the
actual aendance
duraon equals to the overall aendance duraon (includes break me).
8. Se
t the related aendance me parameters as the following:
Start/End-Work Time
Set the start-work me and end-work-me.
Valid Check-in/out Time
On the me bar, adjust the yellow bar to set the metable during which the check-in or
check-out is valid.
Calculated as
Set the duraon calculated as the actual work duraon.
Late/Early Leave Allowable
Set the
metable for late or early leave.
9. Set absence related parameters.
Check-In, Late for
You can set the late me
duraon for the employee who has checked in but is late for work.
If the employee exceeds the required me period, his/her aendance data will be marked as
absent.
Check-Out, Early Leave for
You can set the early leave me duraon for the employee who checks out earlier than the
normal lea
ve me, and his/her aendance data will be marked as absent.
No Check-in
If the employee does not check in, his/her aendance data may be marked as absent or late.
No Check
-Out
If the employee does not check out, his/her aendance data may be marked as absent or
early leave.
10. Click Save to add the metable.
11. Oponal: P
erform one or more following operaons aer adding metable.
Edit Timetable Select a metable from the list to edit related informaon.
Delete Timetable Select a metable from the list and click Dele
te to delete it.
DS-K1T341A Series Face
Recognion Terminal User Manual
159