HIKVISION DS-K1T341AMF User Manual

Figure 7-10 Access Control Parameters
The available parameters descripons are as follows:
Table 7-2 Access Control Parameters Descripons
Parameter Descripon
Terminal Auth. Mode (Terminal
Authencaon Mode)
Select the face recognion terminal's authencaon mode. You
can also customize the authencaon mode.
Note
• Only the device with the ngerprint module supports the
ngerprint related funcon.
• Biometric recognion products are not 100% applicable to
an-spoong environments. If you require a higher security
le
vel, use mulple
authencaon modes.
• If you adopt mulple authencaon modes, you should
authencate other methods before authencang face.
Reader Auth. Mode (Card
Reader Authencaon Mode)
Select the card reader's authencaon mode.
Enable NFC Card Enable the funcon and you can present the NFC card to
authencate.
Door Contact You can select "Open (Remain Open)" or "Close (Remian
Closed)" according to your actual needs. By default, it is Close
(Remian Closed).
DS-K1T341A Series Face Recognion Terminal User Manual
46

HIKVISION DS-K1T341AMF Specifications

General

Model	DS-K1T341AMF
Category	Touch terminals
Operating System	Linux
Resolution	480 × 272
WDR	Yes
Face Capacity	3000
Event Capacity	100, 000
Communication Mode	TCP/IP, Wi-Fi
Working Temperature	-10°C to 55°C
RAM	512 MB
Screen Type	LCD
Camera	2 MP
Face Recognition Distance	0.3 m to 1.5 m
Face Recognition Accuracy	99%
Face Recognition Duration	< 0.2 s
Power Supply	12 VDC/2 A
Working Humidity	10% to 90%
Screen Size	4.3 inch