Face Recognition Terminal User Manual
44
5.7 Authenticating Identity
Purpose:
After setting network, system parameters and adding user, you can go back to the initial page for
identity authentication.
The system will authenticate person according to the configured authentication mode.
You can authenticate identity via 1:1 matching or 1:N matching.
Note: If you require a higher security level, do not use single authentication mode.
Compare the captured face picture or the collected fingerprint picture with all
face pictures or all fingerprint pictures stored in the device
When swiping card or ID card, compare the captured face picture or the
collected fingerprint with the information stored in the card (or ID card).
5.7.1 Authenticating via 1:1 Matching
Steps:
1. If the authentication mode is Card and Face Picture, Card and Face Picture and Fingerprint, or
Auto, swipe card in the card swiping area.
Note: The card can be normal IC card, encrypted card, or ID card.
If the QR Code Scanning function is enabled, you can put the QR code in front of the device
camera to authenticate via QR code.
2. (Optional) If the Blacklist Authentication Mode function is enabled, the device will compare the
authentication information with the blacklist.
To Next Page
Loading...
Need help?
General
