To Next Page

To Previous Page

Face Recognition Terminal User Manual

If the user is in the blacklist, a prompt of identity exception will pop up and the device will send

a blacklist alarm to the control center.

Note: For details about enabling the Blacklist Authentication Mode function, see 5.3.2 System

Settings.

3. If the authentication mode is Card and Face Picture, or Auto, position the face looking at the

camera to authenticate face.

If the authentication mode is Card and Face Picture and Fingerprint, after authenticating face

completely, authenticate the fingerprint on the fingerprint module when the prompt “Continue

to authenticate” will pop up.

If authentication succeeded, the prompt “Authenticated” will pop up.

Notes:

 For better face picture authentication, the user height should between 140 cm and 190 cm

and the distance between the user and the device should be between 30 cm and 100 cm.

 For detailed information about scanning fingerprint, see Chapter 6 Tips for Scanning

Fingerprint.

 For detailed information about authenticating face picture, see Appendix A Tips When

Collecting/Comparing Face Picture.

5.7.2 Authenticating via 1:N Matching

If the authentication mode is Face Picture or Auto, position the face looking at the camera to start

face picture authentication.

If authentication completed, a prompt “Authenticated” will pop up.

5.7.3 Authenticating via 1:1 Matching and 1:N Matching

Steps:

1. If the authentication mode is Fingerprint and Face Picture, authenticate fingerprint first

according to the prompt on the device screen.

The device will compare the fingerprint with the fingerprint information in the device database

(1:N Matching).

If authentication completed, a prompt “Continue to authenticate” will pop up.

2. Front the face looking at the camera to start face picture authentication.

The device will compare the captured face picture with the user information gained from the

last step (1:1 Matching).