HIKVISION DS-K3G411 Series - Chapter 2 System Wiring

Chapter 2 System Wiring
The preparaon before installaon and general wiring.
Steps
1. Draw a central line on the
installaon surface of the le or right pedestal.
2. Draw other parallel lines for installing the other pedestals.
Note
The distance between the nearest two line is 581+200 mm. L represents the lane width.
3. Slong on the installaon surface and dig installaon holes according to the hole posion
diagram.
Figure 2-1 Hole Posion Diagram
4. Bury cables. Each lane buries 1 network cable and 1 high voltage cable. For details, see the
system wiring diagram below.
Figure 2-2 System Wiring Diagram
DS-K3G411 Series Tripod Turnsle Quick Start Guide
3