HIKVISION DS-K3G411 Series - Wiegand Wiring; Barrier Control Wiring

To Next Page

To Previous Page

4.4.5 Wiegand Wiring

Note

Connect the OK/ERR/BZ if the access controller should control the LED and buzzer of the Wiegand

card reader.

4.4.6 Barrier Control Wiring

By default, the barrier has connected with the main control board. If possible, the device can

connect with a third party control board to control the third party barriers. Interface D1 controls

barrier opening for entrance, while interface D2 controls barrier opening for exit.

Note

The output signal is relay. The terminals cannot connect with the devices carrying voltage.

DS-K3G411 Series Tripod Turnsle Quick Start Guide