HIKVISION DS-K3G411 Series - Chapter 3 Installation; Disassemble Pedestals; Install Pedestals

Chapter 3 Installaon
3.1 Disassemble Pedestals
Before installaon, you should use the key to open the pedestals.
View the pictures below to nd the lock holes.
Figure 3-1 Lock Holes
3.2 Install Pedestals
Before You Start
Prepare for the installaon tools, check the device and the accessories, and clear the installaon
base.
Steps
Note
• The device should be installed on the concrete surface or other
non-ammable surfaces.
• No face recognion terminal installed: If the installaon area is too close to the wall, make sure
the distance between the pedestal and the wall should be more than 20 mm, or the surface may
be scratched.
DS-K3G411 Series Tripod Turnsle Quick Start Guide
5