HIKVISION DS-K3G411 Series - Chapter 4 General Wiring; Components Introduction; Wiring Electric Supply

Chapter 4 General Wiring
4.1 Components Introducon
By default, basic components of the turnsle are connected well. The turnsle supports wiring the
AC electric supply for the whole system's power supply.
Note
The voltage uctuaon of the electric supply is between 100 VAC and 220 VAC, 50 to 60 Hz.
The picture displayed below describes each component's posion on the turnsle.
Figure 4-1 Components Diagram 1
4.2 Wiring Electric Supply
Wire electric supply with the switch in the pedestal. Terminal L and terminal N are on the switch,
while terminal PE should connect to a ground wire (yellow and green wire).
DS-K3G411 Series Tripod Turnsle Quick Start Guide
9