HIKVISION DS-K3G411 Series - Wire Network Switch

To Next Page

To Previous Page

Warning

Terminal PE should connect to a ground wire to avoid hazard when people touching the device.

Note

• The cable bare part should be no more than 8 mm. If possible, wear an

insulaon cap at the end

of the bare cable. Make sure there’s no bare copper or cable aer the wiring.

• The Terminal L and the Terminal N cannot be wired reversely. Do not wire the input and output

terminal reversely.

• To avoid people injury and device damage, when tesng, the ground resistance of the

equipotenal points should not be larger than 2 Ω。

4.3 Wire Network Switch

Connect the network cable and the network switch.

Steps

1. Use the key to open the side panel of the pedestal.

DS-K3G411 Series Tripod Turnsle Quick Start Guide