HIKVISION DS-K3G411 Series - Chapter 5 Device Settings; Pair Keyfob (Optional)

Chapter 5 Device Sengs
You can also set the turnsle to passing mode and memory mode, pair the keyfob, inialize the
hardware, switching between RS-485
communicaon mode and RS-232 communicaon mode, and
view relay output NO/NC diagram by seng the DIP switch on the main control board.
• Normal Mode: The device will work properly.
• Passing Mode: There are 9 passing modes, including controlled
bi-direcon, controlled entrance
and prohibited exit, controlled entrance and free exit, free bi-direcon, free entrance and
controlled exit, free entrance and prohibited exit, prohibited bi-direcon, prohibited entrance
and free exit.
• Memory Mode: By default, the memory mode is enabled. When
mulple cards are presented
and authencated, it allows mulple persons passing through the lane. When it counts the
passing people number is equal to the card presented
mes, or no person passing through the
lane aer the last person passing, the barriers will be closed.
Note
You can also set the DIP switch on the main control board to control the entrance and exit
controlling type, keyfob pairing, etc. For details about the DIP switch value, see .
5.1 Pair Keyfob (Oponal)
Pair the remote control to the device through DIP switch to open/close the barrier remotely.
Before You Start
Ask our technique supports or sales and purchase the keyfob.
Steps
1. Power o the turnsle.
2. Set the No.4 switch of the 8-digit DIP Switch on the main control board to the ON side.
3. Power on the turnsle and it will enter the keyfob pairing mode.
4. Hold the Close buon for more than 10 seconds.
The keyfob's indicator of the will
ash twice if the pairing is completed.
5. Set the DIP switch as OFF (the number side), and reboot the turnsle to take eect.
DS-K3G411 Series Tripod Turnsle Quick Start Guide
30