HIKVISION DS-K3G411 Series - Relay Output NO;NC Settings

To Next Page

To Previous Page

2. Disconnect the power and reboot the device. The device buzzer buzzes a long beep.

3. When the beep stopped, plug the jumper cap back.

4. Disconnect the power and power on the device again.

Cauon

The inializaon of the device will restore all the parameters to the default seng and all the

device events are deleted.

Note

Make sure no persons are in the lane when powering on the device.

5.3 Relay Output NO/NC Sengs

5.3.1 Alarm Relay Output Mode (NO/NC)

Alarm Relay Output Mode (NO):

Alarm Relay Output Mode (NC):

DS-K3G411 Series Tripod Turnsle Quick Start Guide